EnerSys Alpha Micro 100, Installation And Operation Manual

Page: 72 / 88

71
017-220-J0 Rev C
9.7.8 200-event Log
Up to 200 events are stored in the
Alpha Micro 100
log. If more than 200 events occur, the oldest is over-written.
Procedure:
1. To see the log, type event (all lower case) and press Enter . The events are listed starting with the most recent
and appear as:
See below for details on these
readouts.
eventX=12/25/99 01:45:59 0000000000000000, 0000000000000000, 000
Event Date Time Alarm Fault Mode
Date and Time formats depend
on selected display format
Alarm: When the following bits show a 1,
the following alarms are displayed.
Fault: When the following bits show a 1,
the following faults are displayed..
Table T — Event Codes
Code Mode Code Mode Code Mode
000 Standby 003 Boost 1 006 Inverter
001 Line 004 Buck 1 009 Shutdown
002 Boost 2 005 Buck 2 010 Bypass
2. If less than 200 events occurred, the last entry will appear as:
3. To clear the log, type eventclr and press Enter . It takes the
Alpha Micro 100
30 seconds to clear the log. Do not
enter any other commands during this time.
4. To see a specific event, type eventX where X is from 1 to 200 and press Enter . To see a range of events (for
example, events 20 to 30), type eventX-X where X are events from 1 to 200 and press Enter . To clear the log,
type eventclr and press Enter . It takes the
Alpha Micro 100
30 seconds to clear the log. Do not enter any other
commands during this time.
5. To see a specific event, type eventX where X is from 1 to 200 and press Enter . To see a range of events (for
example, events 20 to 30), type eventX-X where X are events from 1 to 200 and press Enter .
eventX=00/00/00 00:00:00 0000000000000000, 0000000000000000, 000
DC Overload
Power Outage
Output Voltage Low