EnerSys Alpha Micro 100, Installation And Operation Manual

Page: 70 / 88

69
017-220-J0 Rev C
9.7.5 Setting the Date and Time
Table S — Setting the Date and Time
Enter command UPS display Description
clock and press Enter *clock=12/31/07 22:00:00 Returns the current date and time.
clock=010111

120000 and
press Enter *clock=01/01/11 12:00:00
†
Sets the date and time to Jan 01, 2011, 12:00 pm
Notes:
1. Time is displayed in the 24 hours clock format.
2. Changing the mm/dd/yy format with DATE SEL on the Control menu does not change the USB mm/dd/yy for-
mat.
3. If the Alpha Micro 100 has been in storage or switched off for a prolonged period, the backup Lithium coin
battery could be drained and may not correctly keep a backup of the date and time you entered. After switching
on the Alpha Micro 100 check the date and time settings. The Alpha Micro 100 should display the current date
and time. If it displays the date as "00:01:00", then the battery is spent and you need to ask a qualified service
personnel to replace the lithium coin battery. See Chapter "12. Troubleshooting".
* Indicates that the Alpha Micro 100 has responded to the command you entered.
† If the date or time change is invalid, the Alpha Micro 100 will return the time and date it was set to before you tried
making the change. The date and time must be entered as one complete line command. You cannot change only the
time or the date alone. Both must be set at the same time. If you make a mistake, press
Enter
and try again.