Eneo HDD-20, Installation Manual

Page: 87 / 92

OSD Manual
87
z
AUTOPAN LINE
Select an auto-pan line that the Dome Camera should execute when
an alarm pin is triggered. The auto-pan line(s) should be defined prior
either in the <AUTOPAN> setup menu or through the keyboard.
z
CRUISE LINE
Select a cruise line that the Dome Camera should execute when an
alarm pin is triggered. The cruise line(s) should be defined prior either
in the <CRUISE> setup menu or through the keyboard.
¾
DWELL TIME
The Dwell Time is duration of executing an alarm action. If the <PRESET>
mode is selected, the Dome Camera will go to the selected preset position
and stay there for a user-defined period of time (1~127seconds/Always)
when alarm takes place until alarm condition is released or users rotate
the joystick to change the status of the Dome Camera.
If other modes (SEQUENCE/AUTOPAN/CRUISE) have been selected, the
camera will keep executing the selected mode (DWELL TIME: ALWAYS)
until alarm condition is released or users rotate the joystick to change the
status of the Dome Camera.
NOTE:
The dwell time is only adjustable when selecting
<PRESET> as the alarm action. When the dwell time is up, the
Dome Camera will go back to its trigger position and recheck alarm
pin status.
¾
ALARM PRIORITY
Set alarm priority from <1> to <4> for each alarm pin. If two or more alarms
are triggered at the same time, smaller alarm priority number will have
higher priority of being handled. The default alarm priority is <1>.
¾
EXIT
Exit <ALARM SETTING> menu and go back to the <MAIN PAGE3> to
carry on other setups.