Eneo HDD-20, Installation Manual

Page: 74 / 92

OSD Manual
74
¾
PT POSITION
PT Position can display the Pan/Tilt position of Dome Camera on the
screen. Refer to User Manual (up to page 36) for the item displayed
location.
z
PT DISPLAY
Turn the item to <ON> to display the pan/tilt position on the screen.
The display format will be “XX YYY/ YY”.
z
SET PAN ZERO
By using <SET PAN ZERO> function, user can set north direction as
coordinate zero.
The display will show eight different directions including N, E, S, W,
NE, SE, SW, SN depending on the closest direction Dome Camera
faces. The PAN range is from 0° to 359°, and the TILT range is from
10° to -90°. After lower than -90°, the PAN degree will be automatically
added 180°.
Press <TO SAVE> to save the pan zero setting.
z
EXIT SET
Exit <PT POSITION> menu and go back to <SETUP MENU 2> to set
other functions.
¾
SPEED BY ZOOM
If the item is set to <ON>, the pan/tilt speed will be automatically adjusted
by internal algorithm when zooming. The larger zoom ratio leads to the
lower rotating speed.
¾
AUTO CALI. (Auto Calibration)
There are one horizontal point and one vertical infrared rays check point in
each dome. During installation or maintenance, the Dome Camera’s
position may be moved. Therefore, the relative distance between the
original set point and the check point will be changed. If the Auto
Calibration function is enabled, the Dome Camera will automatically detect
the matter and reset the horizontal point back to the original position.
¾