Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 86 / 198

Commissioning Proline Promag W 400 HART
86 Hauser
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Volume flow unit – Select volume flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• l/h
• gal/min (us)
Volume unit – Select volume unit. Unit choose list Country-specific:
• m³
• gal (us)
Conductivity unit The On option is selected in
the Conductivity
measurement parameter
parameter.
Select conductivity unit.
Effect
The selected unit applies for:
• Current output
• Frequency output
• Switch output
• Simulation process variable
Unit choose list µS/cm
Temperature unit – Select temperature unit.
Result
The selected unit applies for:
•
Maximum value parameter
• Minimum value parameter
Unit choose list Country-specific:
• °C
• °F
Mass flow unit – Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit – Select mass unit. Unit choose list Country-specific:
• kg
• lb
Density unit – Select density unit.
Result
The selected unit applies for:
• Output
• Simulation process variable
Unit choose list Country-specific:
• kg/l
• lb/ft³
10.4.3 Configuring the status input
The Status input submenu guides the user systematically through all the parameters that
have to be set for configuring the status input.
The submenu appears only if the device was ordered with a status input .
Navigation
"Setup" menu → Status input
Structure of the submenu
‣
Status input
Assign status input →  87