Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 90 / 198

Commissioning Proline Promag W 400 HART
90 Hauser
Failure mode →  90
Invert output signal →  90
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output. • Pulse
• Frequency
• Switch Pulse
Assign pulse output In the Operating mode
parameter, the Pulse option is
selected.
Select process variable for
pulse output. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
Off
Value per pulse In the Operating mode
parameter, the Pulse option is
selected and one of the
following options is selected in
the
Assign pulse output
parameter (→  90):
• Mass flow
• Volume flow
Enter measured value at which
a pulse is output. Signed floating-point
number Depends on country
and nominal
diameter
Pulse width In the Operating mode
parameter, the Pulse option is
selected and one of the
following options is selected in
the
Assign pulse output
parameter (→  90):
• Mass flow
• Volume flow
Define time width of the
output pulse. 0.05 to 2 000 ms 100 ms
Failure mode In the Operating mode
parameter, the Pulse option is
selected and one of the
following options is selected in
the
Assign pulse output
parameter (→  90):
• Mass flow
• Volume flow
Define output behavior in
alarm condition. • Actual value
• No pulses No pulses
Invert output signal – Invert the output signal. • No
• Yes No
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output 1 to n
‣
Pulse/frequency/switch output 1
to n
Operating mode →  91
Assign frequency output →  91
Minimum frequency value →  91