Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 98 / 198

Commissioning Proline Promag W 400 HART
98 Hauser
Parameter Prerequisite Description User entry /
Selection
Factory setting
Assign pulse output In the Operating mode
parameter, the Pulse option is
selected.
Select process variable for
pulse output. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
Off
Measuring mode output 1 to n – Select measuring mode for
output. • Forward flow
• Forward/Reverse
flow
• Reverse flow
• Reverse flow
compensation
Forward flow
* Visibility depends on order options or device settings
10.4.8 Configuring the low flow cut off
The Low flow cut off wizard systematically guides the user through all the parameters
that must be set to configure low flow cut off.
Navigation
"Setup" menu → Low flow cut off
‣
Low flow cut off
Assign process variable →  98
On value low flow cutoff →  98
Off value low flow cutoff →  99
Pressure shock suppression →  99
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Assign process variable – Select process variable for low
flow cut off. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
Volume flow
On value low flow cutoff One of the following options is
selected in the
Assign process
variable parameter (→  98):
• Volume flow
• Mass flow
Enter on value for low flow cut
off. Positive floating-
point number Depends on country
and nominal
diameter