37742-0-1116
Page 24
SPECIAL VENT SYSTEMS
•
Simpson Duravent® GS 5” x 8”
•
American Metal Products 5” x 8”
•
Selkirk Direct-Temp® 5” x 8”
•
Security Secure Vent® 5” x 8”
•
Excel DV Venting 5” x 8”
•
Empire Flexvent Kit DVVK-5F
•
BDM - 5” x 8”
•
Metal Fab 5” x 8”
Figure 47
GENERIC MODEL SHOWN
VENT SYSTEM IDENTIFICATION
FLASHING
STORM
COLLAR
VERTICAL
TERMINATION
(THREE 90°
ELBOWS MAX)
WALL THIMBLE
HORIZONTAL TERMINATION
(THREE 90° ELBOWS MAX)
90° ELBOW
OR
45° ELBOW
90° ELBOW
CEILING
FIRE STOP
WALL STRAP
PIPE LENGTH
WALL THIMBLE SPACER
(DVCT36 ONLY)
Special DV Vent Kits
Available from Empire Comfort Systems, Inc. dealers.
DVVK-5RP
Direct-Vent Fireplace Vent Kit for Rear Vent, 6
to 12 inch wall thickness, Includes 58DVA-06,
58DVA-WT, and 58DVAHC
DVVK-5TP
Direct-Vent Fireplace Vent Kit for Top Vent,
Thru-the-wall,
4 to 6 inch wall thickness, Includes 58DVA-E90,
58DVA-HC, 58DVA-06, and 58DVA-WT
DVVK-5VP
Direct Vent Fireplace Vent Kit - Vertical,
Includes
58DVA-VCH, 58DVA-SC, and 58DVA-F6
DVVK-5TS
Top Vent Kit (Horizontal) - 4½" to 6" wall
thickness
(114.3 mm to 152 mm)
DVVK-5F
Horizontal Flex Vent Kit (4' Flex) (1.22m)
Begin the vent system installation by selecting the type of venting
to be installed and the path that it will take. Verify that clearances
are met throughout the path of the venting system.
NOTE:
These fireplaces cannot be vented out the rear.
Determine how the vent system will be terminated out the side of
the house or through the roof. Verify clearances for the termination.
When selecting a vent system for use with the fireplace, refer to the
“Special Vent Systems” section below to determine what systems
are acceptable. Check all clearances and venting components.
Identify if any problems existing in the vent system.
NOTICE: All outer connection joints must be sealed with
aluminum tape, screws or silicone sealant rated above
300°F/149°C. The inner flue joints do not require any sealant.
The following vent systems are acceptable for use with the DVCT36CFP95 and DVCT40CFP95 series fireplaces:
Summary of Contents for DVCT36CFP95-1
Page 37: ...37742 0 1116 Page 37 LOG AND EMBER PLACEMENT 1 Place Ember Bed A onto burner pins 3 and 4 ...
Page 38: ...37742 0 1116 Page 38 LOG PLACEMENT 2 Place Log B onto burner pins 1 and 2 ...
Page 43: ...37742 0 1116 Page 43 LOG PLACEMENT 7 Place Log E onto burner pin 5 and the pin on Ember Bed A ...
Page 55: ...37742 0 1116 Page 55 THIS PAGE IS INTENTIALLY LEFT BLANK ...
