37742-0-1116
Page 10
BLOWER INSTALLATION
Bench Installation
1. Remove Blower Access Panels
(Figure 2).
Figure 2
2. Place Blowers onto blower brackets.
(Figure 3)
Figure 3
3. Bend tab as shown in
(Figure 4)
and secure with
(2) screws.
HAND BEND
TAB INWARD
HAND BEND
TAB INWARD
Figure
4
4. Remove protective connectors on Wire Assembly from
fireplace and discard. Connect Wire Harness to both blowers
and the other end to the Wire Assembly supplied with the
fireplace.
(Figure 5)
TO WIRE ASSEMBLY
(MODULE)
TO WIRE ASSEMBLY
(MODULE)
Figure 5
5. Replace Blower Access Panels removed in step 1
(Figure1).
Installation After Placement of Unit in Wall
1. Remove the following items
(Figure 6).
•
Screen barrier
(See Homeowner’s Manual, Maintenance
and Service).
•
Glass Frame Assembly
(See Homeowner’s Manual,
Maintenance and Service).
•
Liners
(See separate liner instruction document).
Figure 6
2. Remove front and rear burner
(Figure 7).
Figure 7
CAUTION: Sharp edges. Use protective gloves when installing.
Summary of Contents for DVCT36CFP95-1
Page 37: ...37742 0 1116 Page 37 LOG AND EMBER PLACEMENT 1 Place Ember Bed A onto burner pins 3 and 4 ...
Page 38: ...37742 0 1116 Page 38 LOG PLACEMENT 2 Place Log B onto burner pins 1 and 2 ...
Page 43: ...37742 0 1116 Page 43 LOG PLACEMENT 7 Place Log E onto burner pin 5 and the pin on Ember Bed A ...
Page 55: ...37742 0 1116 Page 55 THIS PAGE IS INTENTIALLY LEFT BLANK ...
