4
Technical data
Section 1: Introduction
Owner and operator manual
January 2015
3-9008-001 Rev M
1.2.1
Technical data
Product parameters and limitations:
•
Fluid static pressure:
Material of construction dependent. (Refer to ASME
codes and ANSI specifications when applicable)*
•
Fluid phases:
gas, liquid, vapor
•
Fluids measured:
most hydrocarbons
•
Fluid temperature parameters:
Material of construction dependent. (Refer to ASME
codes).*
•
Orifice plate seal
Refer to ASME codes and ANSI specifications for
material limitations:
Fitting operating limits. Never exceed temperature
operating limits.
w/ Nitrile Seal
Maximum: 250 F (+121 C) Minimum: -30 F (-34 C)
w/ HNBR Seal
Maximum: +300 F (+148 C) Minimum: -20 F (-28 C)
w/ FKM Seal
Maximum: +392 F (+200 C) Minimum: -15 F (-26 C)
w/ FFKM Seal
Maximum: +620 F (+327 C) Minimum: -4 F (-20 C)
•
Differential pressure:
See AGA Report #3
Space limits:
See “Senior Orifice Fitting Technical Guide: DAN-DIF-TG”
Time parameters:
See Orifice Plate changing instructions
Follow all the safety and equipment limits recommended in
of this manual.
It is the owner’s and/or purchaser’s responsibility to comply with these parameters.
PERSONAL PROTECTION HAZARD
Follow all parameters for the Senior Orifice Fitting indicated below.
Failure to do so may result in injury or equipment damage.
