ElektroPhysik 7
If the BAT display flashes during measurement, the
batteries are running low and should be replaced
before the gauge is switched on again. If not, the LC
display will show the permanent BAT warning and
the gauge will switch itself off after about a second.
Note:
Note that the gauge will not make faulty
measurements even if the voltage is very low.
2.2
Replacing the batteries
1.
Place the gauge upside down on a suitable
surface.
2.
Push the lid of the battery compartment in
direction of the arrow and raise the lid of the
compartment.
3.
Remove batteries.
4.
Insert new batteries.
5.
Replace the battery compartment lid.
Replacing the batteries
