Electra KN 24 RC, Service Manual

Page: 134 / 168

14-5
OPTIONAL ACCESSORIES
Revision Y06-02
Service Manual - KN Series
2
Fig.4
● Connect c a pill a ry E to T-valve .
Use Copper se a lin g ga sket between the fl a re nut
a nd the connection to T-valve.
Note:
● Inst a llin g the Copper se a lin g ga sket is m a nd a tory
in order to a void refri g er a nt le a k.
Cooper sealing
gasket
Fig.5
Fig.6
E
T-valve
D
Flare nut
TB 2
TB5
TB4
TB1
Electrical connections for 3PH units:
● Disconnect the wire from point “ 6 ” on m a in ter-
min a l PCB Typhoon a nd isol a te it with isol a tion
t a pe.
● Disconnect the J P1 a nd J P 2 wires from t a bs TB1;
TB8; TB9 on PCB Typhoon.
● Connect Red Wire from F a n S peed Controller to
t a b “ TB8 ” on PCB Typhoon.
● Connect Green Wire from F a n S peed Controller
to T a b “ TB1 ” on PCB Typhoon.
● Connect Y/Green wire from F a n S peed Controller
to g round screw on units p a rtition.
● Return “J P1 ” wire, previously disconnected, to
Electrical connections for 1PH units:
● Disconnect the wire from point “ 6 ” on m a in ter-
min a l outdoor PCB Typhoon a nd isol a te it with
isol a tion t a pe.
● Disconnect the J P1 a nd J P 2 wires from t a bs TB 2 ;
TB4; TB5 on PCB Typhoon.
Connect the Red Wire from F a n S peed Controller
to t a b “ TB4 ” on PCB Typhoon.
● Connect Green Wire from F a n S peed Controller
to t a b “ TB 2” on PCB Typhoon.
● Connect Y/Green wire from F a n S peed Controller
to g round screw on units p a rtition.
● Return “J P1 ” wire, previously disconnected, to
t a b “ TB 2” .
Ground screw
TB 2
TB5
TB4
Ground screw
Fig.5
Fig.4
Fig.6
TB8
TB9
TB1
TB8
TB9