4
INSTALLATION PLACE
CAUTION
Location in the following places may cause malfunction of the machine. (If unavoidable,
please consult your local dealer)
a. There is petrolatum existing.
b. There is salty air surrounding (near the coast)
c. There is caustic gas (the sulfide, for example) existing in the air (near a hot spring).
d. The Volt vibrates violently (in the factories).
e. In buses or cabinets.
f. In kitchen where it is full of oil gas.
g. There is strong electromagnetic wave existing.
h. There are inflammable materials or gas.
i. There is acid or alkaline liquid evaporating.
j. Other special conditions.
NOTICES BEFORE INSTALLATION
1. Select the correct carry-in path.
2. Move this unit as originally packaged as possible .
3. If the air conditioner is installed on a metal part of the building ,it must be electrically insulated
according to the relevant standards to electrical appliances.
1. The indoor unit
•
There is enough room for installation and maintenance.
•
The ceiling is horizontal, and its structure can endure the weight of the indoor unit.
•
The air outlet and the air inlet are not impeded, and the influence of external air is the least.
•
The air flow can reach throughout the room.
•
The connecting pipe and drainpipe could be extracted out easily.
•
There is no direct radiation from heaters.
2. The outdoor unit
•
There is enough room for installation and maintenance.
•
The air outlet and the air inlet are not impeded, and can mot be reached by strong wind.
•
It must be a dry and well ventilating place.
•
The support is flat and horizontal and can stand the weight id the outdoor unit. And will no
additional noise or vibration.
•
Your neighborhood will not feel uncomfortable with the noise or expelled air.
•
There is no leakage of combustible air.
•
It is easy to install the connecting pipe or cables.
•
Determine the air outlet direction where the discharged air is not blocked.
•
A place free of a leakage of combustible gases.
•
In the case that the installation place is exposed to a strong wind such as seaside or high position,
secure the normal fan operation by putting the unit lengthwise along the wall or using a duct or
shield plates.
•
If possible, do not install the unit where it is exposed to direct sunlight.
If necessary, install a blind that does not interfere with the air flow.
•
During the heating mode, the water drained off the outdoor unit. the condensate should be well
drained away by the drain hole to an appropriate place, so as not to interfere other people or
public.
•
Select the position where it will not be subject to snow drifts, accumulation of leaves or other
seasonal debris. It is important that air flow for the outdoor unit is not impeded as this will result in
reduction ion heating or cooling performance.
SZ000289/En
06/23/2004, 2:39 PM
16
Summary of Contents for KN 24 RC
