EKOM DK50 2x4VR/110/M, User Manual

Page: 30 / 168

INSTALLATION
NP-DK50 2x4VR 110-AD-A-1_09-2020 30 09/2020
13. COMMISSIONING

Make sure all transport stabilizers were removed.

Check that all compressed air hose connections are correct

Check correct connection to the mains (see chap. 12).

Check the circuit breaker position, it must be in the “I” position. If the main switch (2) is in the “0”
position, tur
n it to the “I” position. (Fig. 20).

For cabinet-mounted compressors, turn the main switch (4) on the front side of the cabinet into
the "I" position; a green indicator indicates the equipment is in operation. (Fig. 20).

Check connection of the cabinet connector to the compressor (Fig. 18)

Check connection of the cabinet manometer hose to the pneumatic block of the compressor (Fig.
15).

Check to ensure the compressed air connection between the compressor and dryer is correct.
(Fig. 11)

Check to ensure the hose from the automatic condensate drain is connected to the collection
vessel.

Check the connection of the dryer control and power signal wiring from the compressor. (Fig.
16).
The compressor is not equipped with a backup power supply.