Edge-Core ES4528V-38, Management Manual, Page: 371 / 396

– 371 –
31
F
IRMWARE
C
OMMANDS
This section describes commands used to upgrade firmware via a TFTP
server.
firmware load
This command loads new firmware from a TFTP server using an IPv4
address.
S
YNTAX
firmware load tftp-server file-name
tftp-server - TFTP server’s IPv4 address. Valid IP addresses consist
of four numbers, 0 to 255, separated by periods.
file-name - The name of the file to load from the TFTP server. The
destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.). (Valid characters:
A-Z, a-z, 0-9, “.”, “-”, “_”)
C
OMMAND
U
SAGE
◆
You can upgrade the switch’s system firmware by specifying a file
provided by Edgecore. You can download firmware files for your switch
from the Support section of the Edgecore web site at www.edge-
core.com.
◆
After the software image is uploaded, a message announces that the
firmware update has been initiated. After about a minute, the firmware
is updated and the switch is rebooted.
C
AUTION
:
While the firmware is being updated, the switch cannot be
accessed through any management protocol. The front LED flashes Green/
Off at a frequency of 10 Hz while the firmware update is in progress. Do
not reset or power off the device at this time or the switch may fail to
function afterwards.
Table 46: Firmware Commands
Command Function
firmware load Loads new firmware from an IPv4 TFTP server
firmware ipv6 load Loads new firmware from an IPv6 TFTP server