Edge-Core ES4528V-38, Management Manual, Page: 203 / 396

– 203 –
9
S
YSTEM
C
OMMANDS
This section describes commands used to configure information that
uniquely identifies the switch, set the user name and password, reboot the
system, set the time zone, configure the log levels to display, and filter
management access to the switch through specified IP addresses.
Table 16: System Commands
Command Function
system configuration Displays information that uniquely identifies the switch
system reboot Restarts the system
system restore default Restore factory default settings
system contact Sets the name of the administrator responsible for the system
system name Displays or sets the name assigned to the switch system
system location Displays or sets the system location
system password Displays or sets the administrator password
system timezone Displays or sets the time zone for the switch’s internal clock
system log Displays log entries, configures the log levels to display, or clears
the log table
system access
configuration
Displays the access mode and the number of authorized
addresses
system access mode Shows or sets the access mode
system access add Adds IPv4 addresses that are allowed management access
system access ipv6 add Adds IPv6 addresses that are allowed management access
system access delete Deletes an access management entry
system access lookup Displays specified access management entry
system access clear Clears all access management entries
system access statistics Displays or clears access management statistics