Edge-Core ES4528V-38, Management Manual, Page: 243 / 396

– 243 –
13
L
INK
A
GGREGATION
C
OMMANDS
This section describes commands used to configures static port
aggregation, including member assignment, and load balancing methods.
U
SAGE
G
UIDELINES
◆ You can create multiple links between devices that work as one virtual,
aggregate link. A port trunk offers a dramatic increase in bandwidth for
network segments where bottlenecks exist, as well as providing a fault-
tolerant link between two switches.
◆ When configuring static trunks, you may not be able to link switches of
different types, depending on the manufacturer's implementation.
However, note that the static trunks on this switch are Cisco
EtherChannel compatible.
◆ To avoid creating a loop in the network, be sure you add a static trunk
via the configuration interface before connecting the ports, and also
disconnect the ports before removing a static trunk via the
configuration interface.
◆ Besides balancing the load across each port in the trunk, the other
ports provide redundancy by taking over the load if a port in the trunk
fails. However, before making any physical connections between
devices, configure the trunk on the devices at both ends. When using a
port trunk, take note of the following points:
■
Finish configuring port trunks before you connect the corresponding
network cables between switches to avoid creating a loop.
■
You can create up to 14 trunks on a switch, with up to 16 ports per
trunk.
■
The ports at both ends of a connection must be configured as trunk
ports.
Table 21: Link Aggregation Commands
Command Function
aggr configuration Displays configuration settings for all link aggregation groups
aggr add Adds or modifies member ports for a link aggregation group
aggr delete Deletes a link aggregation group
aggr lookup Displays information on the specified link aggregation group
aggr mode Selects the load-balance method to apply to all link aggregation
groups on the switch