Edge-Core ES4528V-38, Management Manual, Page: 258 / 396

C
HAPTER
15
| RSTP Commands
– 258 –
E
XAMPLE
RSTP>delay 20
RSTP>
rstp txhold
This command displays or sets RSTP Transmit Hold Count.
S
YNTAX
rstp txhold [ transmit-hold ]
transmit-hold - The number of BPDUs a bridge port can send per
second. When exceeded, transmission of the next BPDU will be
delayed. (Range: 1-10)
D
EFAULT
S
ETTING
6
E
XAMPLE
RSTP>txhold 10
RSTP>
rstp version
This command displays or sets the type of spanning tree used on this
switch (RSTP or STP-compatible).
S
YNTAX
rstp version [ compatible | normal ]
compatible - Compatible with STP.
normal - RSTP
D
EFAULT
S
ETTING
Normal
C
OMMAND
U
SAGE
◆
RSTP supports connections to either RSTP or STP nodes by monitoring
the incoming protocol messages and dynamically adjusting the type of
protocol messages the RSTP node transmits, as described below:
◆
In normal mode, if RSTP is using 802.1D BPDUs on a port and receives
an RSTP BPDU after the migration delay expires, RSTP restarts the
migration delay timer and begins using RSTP BPDUs on that port.
◆
In compatible mode, if the switch receives an 802.1D BPDU (i.e., STP
BPDU) after a port's migration delay timer expires, the switch assumes
it is connected to an 802.1D bridge and starts using only 802.1D
BPDUs.