SAFETY NOTICES
When combining this product with other components, the safety
aspects of the products may interfere with each other.
If this product is used in combination with other components of
a rescue/fall arrest system, users must acquaint themselves with
the enclosed recommendations, notes and instructions for these
components prior to use and comply with them. This equipment
should only be used in connection with parts of personal protec-
tive equipment (PPE) bearing the CE-symbol to protect individuals
against falls from heights.
Only a fall arrest harness in accordance with EN 361 may be used
with a fall arrest system!
If original components are modified or removed from the product,
its safety aspects may be restricted. The equipment should not be
modified in any way or altered to allow attachment of additional
parts without the manufacturer’s written recommendation.
The equipment must be checked for possible damage before and
after each use. It must be ensured that the equipment is service-
able and fully functional. The equipment must be discarded imme-
diately if there is even the slightest doubt as to its serviceability.
WARNING!
The products must be kept away from damaging envi-
ronments. This includes contact with corrosive and aggressive sub-
stances (e.g. acids, alkalis, soldering water, oils, cleaning agents),
as well as extreme temperatures and flying sparks.
In addition, sharp edges, wetness and especially icing-up can
diminish the stability of textiles!
If hazard assessment performed directly before start of the work
shows that the equipment may be dragged across an edge in case
of a fall, suitable precautions must be taken.
CLIMATE REQUIREMENTS
The permanent use temperature of the product (in dry condition)
ranges from approx. -20°C to +55°C.
LIFESPAN AND REPLACEMENT
The lifespan of the product mainly depends mainly on the way and
frequency in which it is used and external infl uences.
Products made from synthetic fibre (polyamide, polyester, dynee-
ma) are subject to a certain ageing process even if they are not
used. This is caused by the intensivity of UV-rays and environ-
mental influences. When the usable period has elapsed or latest
at the end of the maximum service life, the product must be
removed from use.
Maximum lifespan
under optimal storage conditions (see section
on storage) and without use: 12 years
Occasional use
Occasional and appropriate use without obvious wear and tear and
with optimal storage: 10 years.
Frequent or extreme use,
catch load
Following a fall load or in the event of damage, the personal
protection equipment product should be withdrawn from use
immediately and passed on to an expert or to the manufacturer
for checking with a written confirmation to this effect and/or, if
necessary, to be repaired.
As a general rule, PPE products must be replaced
immediately
if, for instance, products with webbing have frayed edges or if
fibres are torn out of the weave, if the stitching shows signs of
damage and/or abrasion or if the product has been in contact
with chemicals.
Ropes or products with ropes must be replaced
immediately
if
they have been involved in an extreme fall (fall factor >1) or if the
sheath has been damaged (so that the core is visible) or if it has
been in contact with chemicals.
Repairs may only be carried out by the manufacturer or in accord-
ance with procedures recommended by the manufacturer.
54526_GAL_Saf_Verbindungsmittel_MS_140513.indd 13
54526_GAL_Saf_Verbindungsmittel_MS_140513.indd 13
13.05.2014 12:31:36
13.05.2014 12:31:36
