Eddyfi Technologies LYFT, User Manual

Page: 55 / 123

Workflow overview
| 39
Figure 3–11 PEC Autoset dialog box
2. Place your probe on the nominal area of your component.
3. In the PEC Autoset dialog box, tap Run PEC Autoset .
4. To see the signal from your probe, tap Get A-Scan Sample .
5.
While the probe is still on the nominal area of your component, in the front stage, on the Setup
ribbon, tap WT Calibration .
The Wall Thickness Calibration dialog box opens.
Figure 3–12 Wall Thickness Calibration dialog box
6.
Select
New Measurement .
7. Select Nominal .
8.
Tap Calibrate .
9.
While the probe is still on the nominal area of your component, in the front stage, on the Setup
ribbon, tap Repeatability Optimization .
The Repeatability Optimization dialog box opens.