Eddyfi Technologies LYFT, User Manual

Page: 25 / 123

Lyft System Overview
| 9
Table 1-2 Lyft array probe status LEDs
PECA Probes Accessories
For details about PECA probes accessories, refer to the PEC probe catalog . To learn how to install the
probe on a pipe using accessory straps and carriages, see appendix D on page 97
Application-Specific Probes and Accessories
For details about the splash zone, underwater, galvanized-steel and tank floor probes, as well as
cables and other PEC accessories, refer to the PEC probe catalog .
Positioning Lyft
Lyft must be properly positioned prior to use so that you do not run the risk of dropping the instrument
or the instrument falling over. Lyft has two safe operating positions: horizontal and tilted. To use Lyft
in a tilted position, simply pull out the stand located at the rear of the instrument until Lyft is at the
desired angle. If you are using Lyft with the optional harness, see Adjusting the Harness on page 84
for details.
Green Red Blue Status
Off Off - Probe unconnected or unable to receive data.
1 Hz blinking
(slow)
Off - Analysis mode : Probe detected and waiting for action.
10 Hz blinking
(normal)
Off - Acquisition mode : Data is being acquired.
PEC Autoset : Routine is running.
Wall thickness calibration : Routine is running.
Repeatability optimization : Routine is running.
20 Hz blinking
(fast)
Off - Dynamic acquisition mode :The probe’s position is outside
the scan zone.
20 Hz blinking
(fast)
20 Hz blinking
(fast)
- PEC Autoset : Routine failed or was canceled.
Wall thickness calibration : Routine failed or was canceled.
Repeatability optimization : Routine failed or was canceled.
On Off - Grid mapping acquisition mode : Probe ready to perform
acquisition.
PEC Autoset : Probe ready to perform routine.
Wall thickness calibration : Probe ready to perform routine.
Repeatability optimization : Probe ready to perform
routine.
Off On - Dynamic acquisition mode : Probe moving too quickly on
sample.
Other circumstances : Error occurred during requested
operation.
- - On Dynamic acquisition mode : Encoder is moving. The blue
LED is switched off if the Red LED is active.
Other circumstances : Unused.
- - Off Dynamic acquisition mode : Encoder is stopped.
Other circumstances : Unused.