SE-1201 Electrocardiograph User Manual Transmitting ECG Data
- 66 -
Chapter 7 Transmitting ECG Data
7.1 Transmitting ECG Data to the PC
ECG data in DAT\PDF\SCP\FDA-XML format can be transmitted to the PC. To transmit ECG
data in DAT format, the Smart ECG Viewer software of the manufacturer must be installed in the
PC. To transmit ECG data in PDF/SCP/FDA-XML format, the FTP receiving software must be
installed in the PC.
CAUTION
It is forbidden to connect or disconnect a U disk, an SD card or a USB printer during the
transmission course.
7.1.1 Transmitting ECG Data in DAT Format through
Ethernet
Cable
1.
Log into the Smart ECG Viewer software.
2.
Connect the electrocardiograph to the network of the PC with an Ethernet cable
recommended by the manufacturer.
NOTE:
1)
If the wireless AP transmission is used, please refer to the user manual delivered
with the wireless AP.
2)
There should be no shield in or around the room where the wireless AP is used, or
else the wireless transmission may fail.
3.
Configure the
Transmission Setup
window.
NOTE:
For more information on configuring network settings, see your Network
Administrator.
1)
Set
Auto Transmission
to
On
.
2)
Set the
Server IP
item to the IP of the PC.
3)
Set the
Local IP
item.
For the cross-network transmission,
a)
Set the first two sections of the
Local IP
item to the first two sections of the IP of the
PC.
b)
Set the third section of the
Local IP
item to the network segment of the
electrocardiograph which depends on the configuration of Router.
