Ecolab 183042, Operating Instructions Manual

Page: 38 / 72

417101637_Lub-O-Mat - 38 - Rev. 03-07.12
6. Start-up
6.1 Connection
Before initial start-up, the Lub-O-Mat must be installed as part of the system as a whole.
The power supply 230 V/50 Hz is provided via the main switch.
The empty signal connector for the suction lance is connected directly to the metering pump
(3-pin plug) of the Lub-O-Mat (see chapter 6.3.1 ). Connector configuration: see the operating
manual for the EMP II E60 metering pump, article no. 417101339.
6.2 Cleaning of conveyor-track lubrication system
• Before the start-up of the system, all components have to be rinsed with hot water (most
effective by hot water) as the system has to be cleaned from left particles of the
mechanical treating.
• For the cleaning of the pipe-system it has to be removed 1 nozzle per bar. In this way
optimum conditions of the flow can be reached and nozzles as well as ball-valve filters are
protected against dirt.
• Before starting the filling-system (facility) we recommend a base-cleaning of the
conveyors. Dirty conveyors can cause problems during the start-up of the lubrication
system and a risk of wearing at the chains and slide-bars especially with dry-lubrication
systems.
• At change of belt lubricant we recommend a base-cleaning of the complete system.
• Please refer to the product recommendations from ECOLAB .
6.3 Diaphragm metering pump EMP II
See operating manual for the EMP II E60
PLUS
diaphragm metering pump, and complete
manual for EMP E60 on CD.
6.3.1 Front view: Diaphragm metering pump EMP II E60
Pos. Description
1 Control knob for setting the stroke length
2 Menu/Exit, up arrow key
3 Menu/Exit, down arrow key
4 Start/Stop key (Enter function)
5 Test-key
6 Graphical display
I Input for low-level advance warning and empty report
II Input for pulse- / standard signal and metering lock
III Output for empty report, fault report and stroke signal
IV Mains power supply
Fig. 6.1