ECKELMANN Compact GLT 3010, Operating Instruction

Page: 78 / 119

Firmware: V2.18 / V-- 26.10.2022 78/119
9.3.2 Setting the CAN bus address using decade switch S2
Connection to the CAN bus
The connection to the CAN bus is made using the terminals 1-4 installed on the left side:
Setting of the CAN bus address (node number) / deactivation of the CAN bus communication
The decade switch S2 specifies the CAN bus address.
Decade switch S2 Switch position CAN bus address
/ node number
(Kn.nnn) Function
1..4 122..125 Assign CAN bus address 122..125 to the
controller
0, 5..9 NONE CAN bus interface deactivated (inactive,
disabled)
The controller is not detected as a CAN bus
node!
For further details about pin assignments, see chapter CAN Bus Assignment .
ATTENTION
After changing the switch position of S2, the controller must be disconnected from the power supply
for a short time so that the new settings will be adopted!
