Firmware: V2.18 / V--
26.10.2022
18/119
•
•
•
Existing installations
In the case of existing installations with an installed system centre CI 4x00, it is
not
possible to use GLT 5010
controllers. The separation of GLT configurations is
not
supported in the CI 4000 series and GLT 3010. Also, in
the case of replacement of a defective GLT 3010 controller, it
must
be replaced by a GLT 3010 controller again.
Backward compatibility
The two concepts are mutually interlocked in the system centre of the CI 5000 series;
mixed operation is not
possible
. The support of the concept of separate GLT configurations is exclusively implemented in the system
centre of the CI 5000 series, i.e. depending on the connected components, either the old previous GLT concept
or the new GLT concept with separation of the GLT configurations is supported. The rules for interlocking are
defined as follows:
If an "old" GLT configuration is stored in the system centre, then the old, previous GLT concept is active.
If a GLT 5010 controller is active on the CAN bus and no "old" GLT configuration has been imported into the
system centre, then the new GLT concept is active.
If a GLT 5010 controller is active on the CAN bus and the component is managed as a participant in the
system centre, it is no longer possible to import the "old" GLT channel configuration into the system centre
via LDSWin.
Nevertheless, if mixed operation of the GLT 5010 controller and GLT 3010 controller takes place, then this is
escalated accordingly via system messages in the system centre; there is - for the components of the variant
that was added later - only "node guarding" (participant monitoring on the CAN bus) of the components.
The rules mentioned below should be understood analogously. If other parameters or indicators are
more suitable for detection, these can be selected after consultation.