Chapter 2
Page 46
Receiver Description and Installation
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate your TV1 using another UHF Pro remote
control (sold separately) by completing the following instructions:
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
screen by pressing
MENU-6-1-8
on the
remote control.
b. Select
Enable
from the
TV1 UHF Pro Setup
screen.
c. Select
System Info
to open the
System Information
screen.
d. Move the highlight to the address for the
Primary Remote Address
as
shown below. This is important - if you do not do this, your remote will
change the receiver's
Secondary Remote Address
and cause your
Remote Control 1 to control the
side of your receiver.
2. Perform the following using the UHF Pro remote that you are going to use
to control TV1:
a. Press and hold the
SAT
mode button about three seconds, until all the
mode buttons light up, and then let go of the
SAT
button. The
SAT
mode button will blink.
b. Use the
NUMBER PAD
buttons to enter any number from
1
to
16
,
except for the number shown by the
Secondary Remote Address
. The
SAT
mode button goes out after you enter each digit, and then lights up
again.
Write down the number you entered:
c. Press the
POUND
(
#
) button. If you entered the address correctly, the
SAT
mode button will flash three times.
d. Press the
RECORD
button.
e. Make sure the
System Information
screen shows that the
Primary
Remote Address
shows
UHF Pro and IR
and that this address
matches the number you entered in step b.
If you set up your receiver to operate the
side using UHF Pro,
the two UHF Pro remotes for this receiver will interfere with
each other when operated at the same time. This may prevent
the remotes from operating the receiver momentarily.
Note
: Highlight the
Primary Remote
Address
.
