Chapter 3
Page 56
Using the System
Star Button
Press the
STAR
button to:
•
Open the
DVR Events
menu.
•
Backspace without deleting while using the
Search
function of your.
Zero Button
Press the
ZERO
button to forward space while using the search function of your
receiver.
Pound Button
Press the
POUND
button to display the
Search
screen.
Recover Button
Press the
RECOVER
button if you accidentally change the channel or video
input on your TV and cannot get the picture back from your satellite receiver.
When you press the
RECOVER
button as described below, the remote control
sends commands to your TV to change channels or video inputs to try to get you
back to watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost
satellite signal (See
Chapter 5 - Reference
for troubleshooting information).
The
following setup is required to use the
RECOVER
button:
•
The remote control must be set up to control the TV and, if installed, the
VCR (see page 106).
•
If a VCR is installed, make sure it is connected as shown on page 41.
•
On a remote TV, the
RECOVER
button must be programmed to tune your
remote TV to the specific channel to receive TV2 programming (for
example, channel 60), using the instructions on page 25.
To use the
RECOVER
button, complete the following instructions:
1. Press and hold the
RECOVER
button until all four mode buttons light, and
then let go of the button. The
SAT
mode button flashes twice and then all
four mode buttons flash three times.
2. Press the
RECOVER
button. Wait for the
TV
or
VCR
mode button to flash
once and then all four mode buttons to flash once.
