Page 127
Installing a Multiple Dish DISH Pro System
12. Connect two RG-6 cables between both ports on your DISH Pro Twin
LNBF and your switch(es) using the switch instructions and the
DISH Pro
Wiring Diagrams
that start on page 128.
13. Select
Check Switch
from the
Point Dish
menu. When the
Check
Switch
menu opens, select
Retest
. When the procedure completes, you
will see the
Installation Summary
screen again. This time you should
see confirmation for all satellites your dishes are pointed at, and “Satellite
reception verified.” You should also see that the switch(es) in your system
has been correctly identified.
Refer to the DISH Pro wiring diagrams for examples of installation
summary screens.
14. Press
CANCEL
to exit this menu, and then
Done
to exit the
Point
Dish
screen. If you have any other receivers in your system, make sure you
run
Check Switch
on each of them, and allow each to take the software
upgrade, as needed.
