Page 35
Connecting the Receiver to the TV(s) in Another Room(s)
23. If desired to remind you of which TV channel your satellite programming is
on, write the channel number you wrote in step 4 on a blank channel sticker
and place it on or near your remote TV(s). The stickers are inside the front
cover of this guide.
24. Confirm Remote Control 2 controls the receiver. See the next section for
instructions.
25. Program Remote Control 2’s RECOVER to the channel you selected in
step 5. See page 36 for instructions.
Confirming Remote Control 2 Operation
After the remote TV(s) have been connected to the
CH 21–69
O
UT
using in-
home cabling using the proceeding steps, do the following to make sure Remote
Control 2 controls the receiver:
1. Press the
SAT
button to put Remote Control 2 in
SAT
mode to control the
satellite receiver.
2. From a remote TV, use the Remote Control 2 arrow keys to move around
the
Point Dish
screen. If you are able to move around in the
Point Dish
screen, you confirmed that Remote Control 2 is controlling the receiver.
Programming the Recover Button for a Remote TV
Now that the channel for the
CH 21–69 O
UT
to the remote TV(s) has been set,
the
RECOVER
button can be programmed to tune your TV back to this
channel.
1. Program Remote Control 2 to control your TV using the instructions in
Control Other Devices with the Remote Controls
on page 106.
2. Press and hold the
TV
mode button until all the other mode buttons light up,
and then let go of the button. The
TV
mode button flashes.
3. Press the
STAR
(
*
) button.
4. Enter the three digits of your channel number. For example, if your remote
TV is set to channel 60, enter
0-6-0
.
5. Press the
POUND
(
#
) button. The TV mode button flashes three times.
Tip: In Dual Mode,
Remote Control 1
is used to control
TV1 menus on the
nearby TV. Remote
Control 2 is used to
control TV2 menus
on the remote
TV(s).
