54
U
SING THE
R
OBOT
C
ONNECTING TO
R
OBOTS
Clean the GUI screen.
Check that there is no
moisture on the exterior
of the screen or
condensation on the
interior of the screen.
Smartbox: If a problem
has been indicated with
the GPS signal, replace
the Smartbox.
Inspect the inside of the
cover and the chassis:
•
• cable condition
(check for cuts or
abrasions)
•
• attachment and
routing of cables
•
• cable electrical
connections
•
• inspect for
corrosion on the
chassis
•
• check the JEA40
connector for
corrosion
•
• check the
charge connector
for corrosion
Frame
Verify that the coil is
securely tightened to the
chassis. Check the coil
electrical connector.
Check that the front
wheel axles rotate freely
and the axle nuts are
securely tightened.
Front wheels: check the
rotation, wheels should
spin freely without
wobbling. Verify that the
wheel bearings are
sealed.
Check the rear tires for
excessive wear, replace
as necessary.
Service Inspections
(indicate condition as appropriate)
Front lift sensors: verify
that the lift sensors
move up and down with
no resistance, lubricate
as necessary.
Check the front and rear
silentblocs for cracking
or splitting, replace as
necessary. Replace the
silentblocs once every
two years regardless of
their condition.
Cutting heads and
cutting system:
•
•
cable condition
(check for cuts or
abrasions)
•
• check the lifting
strap
•
• check for mois-
ture in the inte-
rior of the cutting
motor housing
(always replace
the top seal when
servicing the
cutting motor
housing)
•
• check for exces-
sive lateral move-
ment of the
cutting head
upper and lower
brackets
•
• verify that the
cutting disc spins
freely and does
not wobble
•
•verify that the
anti-friction disc
spins freely (this
disc must spin
independently
from the cutting
disc).
Service Inspections
(indicate condition as appropriate)
DRAFT
05-23-2019
