GB
GB
91
Cancelling the keep warm function
After completing the keep warm function, you can cancel the keep warm function by pressing the button
. The function is cancelled and the “WARM” message disappears from the display. You restart the keep
warm function by pressing again the button
.
Attention
Although it is possible to set up a 24-hour keep warm function, do not leave the finished food in the pressure
cooker until it can spoil.
Heating food
If you need to heat up the food, simply press the button
without starting any cooking program. The
“WARM” message appears and the food starts heating up. When the heating is done, switch off the function by
pressing again the button
.
Cancelling a function or a program
Press the button
to cancel the selected program or function.
Volume control
When you press the buttons
and
in the same time, you set the volume of the beep, the indicator
flashes on the display. When you enter settings, use the control knob to change the value
from levels 0–4.
The set value will be shown on the display.
Cooking instructions
•
Open the lid – turn the lid clockwise and lift it.
•
Remove the inner vessel from the multifunctional pressure cooker.
•
Place the ingredients and the necessary amount of water into the vessel, but keep to the minimum amount
of food given by the MIN line, do not overfill the container above the MAX mark or the maximum amount
of 3 litres of oil.
Cooking without pressure
Use one of the following programs to cook without increased pressure: Fry, Omelette, cake, Slow cook, Jam,
Yoghurt, Crispy, Pizza or Multicook.
You can leave the lid of the pressure cooker open or close it, depending on the program and the cooking
recipe.
If you close the lid:
•
Check if the seal is properly inserted.
Using the pressure cooker with closed lid and without the seal
is not allowed.
•
Close the lid by the handle and turn it counterclockwise until the locking pin clicks into the body of the
cooker. Set the valve control in the position “open” (the arrow must be against the escape steam symbol,
see fig. 25).
•
Use the control knob
to select the required program, the program indicator appears on the display.
•
The default values of temperature and time are shown on the display.
•
The “REHEAT” message shows on the display until the operating temperature is reached. Once the
temperature is reached the countdown starts. The message “REHEAT” is replaced by the message
“COOKING”.
•
Once the program is complete the beep sounds and the keep warm function starts (except for the Fry and
Yoghurt programs). The display shows the message “WARM”.
After finishing the meal preparation, disconnect the multifunctional pressure cooker from the power supply.
