EBS
Ink-Jet Systems
®
EBS-6100
Printer User's Manual
Paragraph 6 - SERVICE and maintenance
20070529#20.5
111
•
select
the
OTHERS
item from the
SERVICE
submenu, type in the service password,
and then select the
CIRCULATE INK
item,
•
Wait for about 30 minutes - during this time ink circulates in a closed circuit through
the ink filter leaving contaminants in the filter,
•
Select
the
INK ON
command in order to finish the ink filtering process.
Replace the main ink filter by following the steps below (see
Fig. 6.3.5.1
):
a).
place a piece of absorbing cloth under the ink filter and prepare a vessel for
consumed ink,
b).
select the
INK FILTER CHANGE
command from the
SERVICE COMMANDS
submenu of the
SERVICE
menu. The following message is displayed:
FILTER CHANGE START,
WAIT FOR NEXT MESSAGE
,
c).
wait at the printer and perform no operations until the following message is displayed:
Change ink filter now.
AFTER change press <enter> !!!
,
d).
unscrew the ink filter outlet connector , from the ink pump and slip it off the ink
pump connector pipe. (All numbers refer to
Fig. 6.3.5.1
),
e).
slip sleeve together with nut off the ink filter outlet tube (please note the
orientation of the sleeve on the tube),
f).
lift the angle connector at the filter input (
IN
) above the ink level in the
R3
container
and undo nut . Do not lower the supply tube connector below the
R3
ink level not to
pour out any ink,
g).
on removing the filter, slip sleeve together with nut off the tube that supplies ink
to the
R3
container. The sleeve is not fit to be used again because it is subject to
distortion (if a distorted sleeve is used once again it may lead to a lack of tightness in
the system),
h).
unscrew the nut from the angle connector (
IN
) of a new ink filter (from the service kit),
i).
place the nut you unscrewed in para
h)
, together with a
new
sleeve (from the service
kit) on the tube that supplies ink to the
R3
container (put on the nut first and then the
sleeve),
j).
screw down the angle connector (
IN
) of a new ink filter to the supply tube connector
you are holding up (with the nut ) bearing the proper filter orientation in mind (the
INLET
marking on the filter body should point at the
R3
container),
k).
put the sleeve together with the nut you have removed in para
e)
onto the outlet
tube of the new ink filter (put on the nut first and then the sleeve). The figure shows in
which direction the components should be fixed,
NOTE:
Sleeve and nut are the original components of the ink pump and
must not
be replaced with other EBS components (such as sleeve and nut ) because
such a replacement may cause the lack of tightness in the system.
l).
screw tight the outlet connector of the new ink filter to the ink pump,
m).
only after all service operations have been completed should the
V
key be
pressed. Then the following message is displayed:
FILTER CHANGED,
ink will be switched on !!!!!
,
and the request to confirm follows,
n).
after you have confirmed that the filter replacement is complete, the printer needs a
few minutes to get back to the ready state and therefore the following message is
displayed:
WAIT 4,5 minutes
Then the end of the process is indicated with the
END OF FILTER CHANGE
message on the display,
o).
press the
V
key to return to the command menu.
Summary of Contents for EBS-6100
Page 1: ...EBS Ink Jet Systems EBS 6100 USER S MANUAL...
Page 2: ......
