Eaton TRSM0515, Service Manual

Page: 74 / 88

19. Shift the mainshaft sliding clutches into all the
gear positions with a screwdriver. If a clutch
cannot be shifted into a gear it indicates that
the gear set is out of time. The right counter-
shaft bearings would then need to be removed
and the countershaft retimed with the main-
shaft. The front box is properly timed if the
sliding clutches can be shifted into all the
mainshaft gears. (Note: Do not shift the trans-
mission into two gears at the same time. This
will prevent the transmission from rotating.)
20. Use a flanged bearing driver to complete
seating of both front and rear bearings.
21. Install snap ring in groove in rear bore of case.
FRONT SECTION REASSEMBLY