Eaton TRSM0515, Service Manual

Page: 80 / 88

8.
9.
10.
Install the spring in the bore and on the plunger.
Partially install the plug. Use the tip of the gear
shift lever to push the plunger back into the bore
to compress the spring. Tighten the plug fully
and then back off 1/2 -1 1/2 turns. Stake the plug
threads in the hole.
Install first-reverse shift bar in upper bore, neu-
tral notches to the front, installing yoke on bar,
fork to the rear.
Install yoke Iockscrew and safety wire.
11. Remove assembly from vise and install the
three tensions balls, one in each bore in top of
housing. Keep bars in neutral.
12. InstalI the three tension springs, one in each
bore in top of housing.
13. Install the tension spring cover. Tighten cap-
screws securely.
FRONT SECTION REASSEMBLY