6. Install snap ring in groove at rear of m/shaft.
7. Insert two large screw drivers between hub of
reverse gear and auxiliary drive gear applying
light downward pressure on handles of screw-
drivers.
9. Install the 1st-reverse clutch over front of main-
shaft and against reverse gear splined washer.
Align slot in sliding clutch with key.
10. Remove long key from keyway in mainshaft.
Install 1st speed gear splined washer on main-
shaft at 1st speed gear location and re-install
the long key to lock splined washer to shaft.
8. Check clearance between the two gears with
feeler gauge. Clearance can be adjusted by re-
placing reverse gear splined washer with dif-
ferent thickness washer. Proper clearance at
this location should be a minimum of .005".
After proper reverse gear clearance has been
set, remove snap ring from rear of mainshaft in
vise, place front (pilot end) of mainshaft in vise.
FRONT SECTION REASSEMBLY
Summary of Contents for TRSM0515
