Eaton TRSM0515, Service Manual

Page: 51 / 88

I. AUXILIARY REASSEMBLY
Cut 6549-9/85
A. To Reassemble and Install the Low
Speed Gear and Tailshaft Assembly.
1.
Make sure magnetic cleaner is installed in
recess in auxiliary case.
3. Place splined spacer in hub of low speed gear,
shoulder toward rear.
2. IMPORTANT: Mark timing teeth on the reduc-
tion gear.
a. Mark any two adjacent gear teeth on low
speed gear.
b. Then, mark the two adjacent teeth which are
directly opposite the first set marked. There
should be the same number of teeth between
the markings on each side of the gear.
4. Install the low speed gear and spacer over rear
of shaft and against shoulder. Clutching teeth
down.
AUXILIARY REASSEMBLY