7
EATON
ET5050 Crimp machine operator´s manual E-EQCR-TT003-E2 May 2019
Machine setup and installation
Hydraulic system preparation
1. After filling or changing the hydraulic oil, the hydraulic system
needs to be manually cycled under a no load condition
to remove air from hydraulic lines before production use.
Reference page 17 for manual operation.
2. Cycle the machine several times by advancing and retracting
the crimp head. Upon completion, the advance and retract
travel will be smooth.
3. Upon completion, leave the crimp head in the fully
retracted position.
Connecting the electric supply
1. Note: The machine has six voltage options. If your electrical
supply changes, factory voltage settings and amperage
settings have to be changed. Contact Eaton customer service
for assistance.
2. The machine is supplied with a 12’ electrical pigtail that
will require wiring to customer supplied plug/service by a
qualified electrician.
3. The connecting plug must be rated for the service connection
and comply with local electrical regulations!
4. After connection to a power source, if the head does not
actuate, the rotation of the electrical motor is incorrect
and two phases must be switched in the electrical plug
or service.
Note: Always cycle the hydraulic system under a no load condition
after filling or changing the hydraulic oil before use.
!
Note: The machine is factory set to customer electrical supply
requirements as noted on tag attached to the electrical disconnect.
(See figure 4)
!
Figure 4
