14
EATON
ET5050 Crimp machine operator´s manual E-EQCR-TT003-E2 May 2019
Operating instructions
Crimp selections – auto mode continued
Press check prompt on bottom of screen to finish selection
process and to display tooling requirements for hose series
selection. (See figure 21).
Figure 21
Step 9
Step 10
1. Load hose & fitting into machine.
2. Position the scribe line on the fitting to the edge of the
tooling. (See Figure 23)
Figure 23
Step 11
Figure 24
Install the defined dies per the tooling installation procedure.
(Page 9) Select the check mark when the correct dies are
securely installed. (See figure 21).
Figure 22
Note: “Current Selection” screen displays selected product, assembly
instructions and appropriate specifications. (See figure 22).
!
Note: Optional back stop aids in positioning the hose and
fitting assembly before crimping. (See figure 24).
!
Never reach into the crimp tooling with your hands while
the electric motor is running! Always make sure there
is adequate safety distance of at least 4.75" (120 mm)
between the crimp tooling and your hands when
inserting a hose fitting.
Caution
!
