Serial Interface Operation
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
83
5.
Type the number of SNMPv3 user to modify and press [Enter].
6.
Type the SNMPv3 user’s name and press [Enter].
7.
Type the old authentication password and/or [Enter] (if not required). The old password is the currently
configured password value. The value is checked before allowing its modification.
8.
Type the new authentication password and/or [Enter] (if not required), with 8 to 24 characters allowed.
9.
Type the old privacy key and/or [Enter] (if not required). The old password is the currently configured
password value. The value is checked before allowing its modification.
10. Type the new privacy key and/or [Enter] (if not required), with 8 to 24 characters allowed.
11. Choose the security level applied to the SNMPv3 user as follows:
l
Disabled
: The SNMPv3 user is disabled. Type
0
and press [Enter].
l
No Auth No Priv
: No authentication password or privacy key is required to access the MIB objects.
Type
1
and press [Enter].
l
Auth No Priv
: An authentication password but no privacy key is required to access the MIB objects.
Type
2
and press [Enter].
l
Auth Priv
: An authentication password and a privacy key are required to access the MIB objects.
Type
3
and press [Enter].
12. Choose the access rights allowed to the SNMPv3 user as follows:
l
No access
: The SNMPv3 user is disabled and has no access to the MIB objects. Type
0
and press
[Enter] (see Figure 60).
l
Read-Only
: The SNMPv3 user can only get the MIB objects. Type
0
and press [Enter].
l
Read/Write:
The SNMPv3 user can get and set the MIB objects. Type
0
and press [Enter].
Figure 60. SNMPv3 USM Users Definition
NOTE
When the authentication password or privacy key (or both) are not required, ignore
the error message indicating a failure at password verification.
