Serial Interface Operation
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
92
The target e-mail receiver configuration requires a valid e-mail receiver account and the account must be
enabled.
Configure the User Access
The Network Management Card allows one superuser account with read/write access privileges and up to eight
multi-users with configurable access privileges.
Configure the Superuser
1.
Access the Serial interface and log in.
2.
Type
1
(Network Management Card Settings) and press [Enter].
3.
Type
8
(Super User Name and Password) and press [Enter].
4.
Type
1
(Super User Username) and press [Enter].
5.
Type the superuser name and press [Enter] (see Figure 66).
6.
Type
2
(Super User Password) and press [Enter].
7.
Type the current superuser password and press [Enter].
8.
Type the new superuser password and press [Enter].
9.
Type the new superuser password again and press [Enter].
Figure 66. Superuser Configuration
Configure Multi-Users
1.
Access the Serial interface and log in.
2.
Type
1
(Network Management Card Settings) and press [Enter].
3.
Type
9
(Multi-Users) and press [Enter].
4.
Type
1
(Modify – Modify a table entry) and press [Enter].
5.
Type the number of the user to configure and press [Enter].
6.
Type the user name and press [Enter].
7.
Type the current user’s password and press [Enter].
8.
Type the new user’s password and press [Enter].
9.
Type the new user’s password again and press [Enter].
NOTE
See “Configure the SMTP” on page 89 and “Configure the Email Receivers” on
page 90.
