Serial Interface Operation
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
93
10. Select the access rights from the following:
l
No Access
: The user is not allowed to access the Web interface. Type
0
and press [Enter].
l
Read-Only
: The user can access the Web interface, but is not allowed to change any settings or
perform actions. Type
1
and press [Enter].
l
Read/Write
: The user can access the Web interface and is allowed to change settings or perform
actions. Type
2
and press [Enter].
Figure 67. Multi-User Configuration
Configure the DNS
When the IPv4 address is automatically obtained by DHCP, the DNS server addresses (primary and secondary)
are provided by the DHCP server.
Nevertheless, you can define DNS IPv4/IPv6 addresses from the Web and Serial interfaces. However, this
configuration is overwritten when the Network Management Card restarts and the IPv4 address is obtained
from a DHCP server that provides DNS addresses.
1.
Access the Serial interface and log in.
2.
Type
1
(Network Management Card Settings) and press [Enter].
3.
Type
2
(Network Settings) and press [Enter].
4.
Type
5
(Primary DNS IP Address) and press [Enter].
5.
Type the IPv4 or IPv6 address of the DNS server and press [Enter].
6.
Type
6
(Secondary DNS IP Address) and press [Enter].
7.
Type the IPv4 or IPv6 address of the DNS server and press [Enter].
