ET35 Series Digital Bridges（LCR）Operating Instructions
Hangzhou Zhongchuang Electron Co., Ltd.
21
When you enter the digital data with more than five digits (including decimal digits
following the decimal point), it will be automatically set to the nearest measurement level.
The page is shown below
3.1.7 DC bias
ET35 has two ways of bias including internal and external DC bias. The range of the
internal DC bias is -2V ~ 2V, and that of the external DC bias is -60V ~ 60V.
Note: the DC bias current set by ET35 is the output current value when the measured
end is short-circuited, and the DC bias voltage is the output voltage when the measured
end is open circuited.
The DC bias can be set in the pages of component measurement and measurement
setup.
Internal DC bias setup steps:
1. Press the [Meas Setup] key.
2. Use the arrow key to select "bias", press the [Enter] key.
3. Use the function key is set to internal.
4. Use the arrow key to select the "partial pieces", press the [Enter] key.
5. Input bias level. Use the numeric input keys. Function keys become marked units
(mV, V). You can use these function keys to enter the unit. When using the [Enter] key to
enter the level, the level value default unit is mV.
The page is shown below
Set the bias to the internal bias
Summary of Contents for ET3501
Page 25: ...ET35 Series Digital Bridges LCR Operating Instructions Hangzhou Zhongchuang Electron Co Ltd 22...
Page 77: ...ET35 Series Digital Bridges LCR Operating Instructions Hangzhou Zhongchuang Electron Co Ltd 74...
Page 93: ...ET35 Series Digital Bridges LCR Operating Instructions Hangzhou Zhongchuang Electron Co Ltd 90...
