58
• Because the receiver and servos will receive power from the 3-in-1 control unit, it will now be
necessary to disable the BEC power of the brushless ESC before connecting it to the receiver. To do
this, it will be necessary to remove the red (positive) lead and connector from the plastic housing that
goes to the receiver, then to insulate it properly to prevent shorting. Use a small screwdriver or knife
blade (and extreme care to prevent injury) to lift the plastic tab that secures the connector in the plastic
housing, then slide it out the back end of the housing. Use tape or shrink tubing to insulate and secure
the exposed connector.
Note: It is extremely important to disable the BEC of the brushless ESC in order to prevent damage
to the other electronics. Remember, BEC power is already supplied to the receiver and servos
through the 3-in-1 control unit throttle and rudder leads.
Summary of Contents for Blade CP
Page 66: ...66 Notes ...
Page 67: ...67 Notes ...