Dynapac Svedala Demag DF 115 P/D, Operation & Maintenance Manual

Page: 175 / 234

F 5.1 11
F_5
.1_
01_G
B.
fm
11-
12
Engine exhaust system (7)
Cleaning of particle filter
m As considerable amount of soot is accu-
mulated in the filter, the cleaning must
be performed under appropriate exhaust
system.
m Clean the filter element removed with
oil-free and grease-free pressure air!
- Marking the flow of direction of the ex-
haust gas on the filter case.
- Remove the filter element by untight-
ening the two clips (a).
- First blow out the inlet side.
m
The pressure of the compressed air can
be max. 5 bars and the nozzle shall not
be closer to the filter edge than 10 cm.
- Carefully blow out all the filter passag-
es.
- Turn around the filter element, and re-
peat the process on the other side as
well.
- Repeat the process until no more carbon residue leaves the filter.
- Replace the filter element, taking care of the proper direction of flow.
A
After cleaning for a short while more soot discharge is expected during operation.
- In case of sticky, oily soot the filter must be heated to about 450°C and the cleaning
shall be carried out preferably with the hot filter.
m
The filter shall not be cleaned with water/steam or detergent in any case!
f
The carbon particles are harmful to your health! In case of filter change or cleaning,
wear appropriate protection gear!
Partikelfilter.eps
a