Dynapac Svedala Demag DF 115 P/D, Operation & Maintenance Manual

Page: 65 / 234

D 1.3 9
D_1
.3_0
1_G
B.
fm
9
-24
Item Designation Brief description
16
(
o
)
Reverse selection
Feeder
The transport direction of the conveyor, applicable separately
to both sides of the conveyor, can be switched to the opposite
direction so that over a short distance it retracts the material
directly before the auger. In this way the loss of material can
be avoided during transport. The conveyor travels about 1 m
in the direction of the hopper.
A
If necessary, press the button as many times as neces-
sary, so that the feeder operates in the opposite direc-
tion over a longer section.
17
Conveyor modes
of operation on the
right/left sides
A - auto: drive lever turned on and continuously regulat-
ed in the tunnel using the material limit switch
B - stop: turned off
C - manual: continuously turned on (full delivery capacity,
(without material mix regulation)
- If the conveyor is to be remote controlled (
o
), then both
switches shall be set to „auto“ position.
18
Tamper (depends
on the screed)
A - auto: drive lever turned on, in normal position turned
off
B - stop: completely turned off
C - manual: continuously turned on
Use „auto“ mode for laying in the basic case.
m
If the switch is in „manual“ position when laying, then it
must be set to „stop“ in normal position. In the opposite
case excessive tampering may take place.
A
Speed regulation (see „Operation manual of screed“)
19
Vibration
(depends on the
screed)
Operation and application similarly to the (tamper) switch.
A
Speed regulation (see „Operation manual of the
screed“).
B
C
A
A
B
C
A
B
C