dynabook E10-S, Maintenance Manual

Page: 103 / 133

3 Diagnostic Programs
Maintenance Manual Satellite Pro E10-S / dynabook E10-S 3-9
3.4 BIOS Update (when motherboard is NOT replaced)
3.2.5 Function Description
If you do not replace the motherboard, please use this menu to update the BIOS.
3.2.6 Update Procedure
1) Startup the Taikan Maintenance Tool, on the initial screen, input [3] and press the [Enter] key.
(Below “BIOS Ver.: 1.30” indicated current menu’s writeable BIOS selected by this tool)
2) The following confirmation message will be displayed, input
[y]
and press the
[Enter]
key to continue BIOS Update.
(Input
[n]
and press the
[Enter]
key to return to the initial screen if you do not want to update BIOS.)
3) BIOS update is started.
(Once the update is completed, press
any
key to reboot the system.)
* Not Replacing the motherboard *
* 3 – BIOS Update for DBIEMD00 (Using BIOS Ver.: 1.30) *
********************************************************************************
* BIOS update (to 1.30) OK? *
* Note: *
* - Don't interrupt/press Power(or un-plug AC) when it is being updated. *
* - Don't remove/plug-in external devices when it is being updated. *
********************************************************************************
Input [y] or [n] & Press [Enter] key:
+---------------------------------------------------------------------------+
| AMI Firmware Update Utility v5.12.03.2074 |
| APL Normal Mode |
| Copyright (c) 1985-2019, American Megatrends International LLC. |
| All rights reserved. Subject to AMI licensing agreement. |
+---------------------------------------------------------------------------+
Reading flash ...................... Done
- System Secure Flash .............. Enabled
- FFS Checksums .................... Pass
- Check RomLayout .................. Pass
Loading File To Verify Memory ...... Done
Erasing Main Block ................. Done
Updating Main Block ................ Done
Verifying Main Block ............... Done
Erasing NVRAM Block ................ Done
Updating NVRAM Block ............... Done
Verifying NVRAM Block .............. Done
Erasing RomHole Block .............. Done
Updating RomHole Block ............. Done
Verifying RomHole Block ............ Done
Process completed.
Press any key to continue . . .
Note: DMI info and OA 3.0 key will be preserved (won’t be initialized).