. .
Dyadic Systems – Mechatronics Cylinder Manual
MF
-005500-EN-20/63
Connect to PC serial port (COM port)
3.2.8. Quick Start – Set Up of Basic Parameters Using the PC Tool (TBVST-EN-SET)
The following sequence of operations will allow you to download a default program into your Mechatronics
Cylinder Controller. This program will over-write any other program currently in the controller.
(1)
Connect the ADP cable to the CN2 jack of the Connector Junction (ADP-2-4) as per figure below.
Connect the SIO cable to the CNA jack of the Connector Junction (ADP-2-4) as per figure below.
(2)
Power up the Mechatronics Cylinder, and connect the SIO cable to the RS232/485 adaptor
(ADP-1) and connect it to the serial port (COM port) of your PC as per the figure below.
(3)
Start the PC Tool software (TBVST-EN).
(4)
The first menu is for communication setup – please select the serial port Number that the ADP-1 is
plugged in to, then click Set. After few seconds, the operation menu will come up as follows.
(5)
Please click the HOMING button, so that the Mechatronics Cylinder will home itself.
ADP Cable (RP9050)
SIO Cable (RP9041)
Connector Junction (ADP-2-4)
RS232/485 Adaptor (ADP-1)
SIO Cable
(RP9041)
CNA CN2
[HOMING] button
If this block is dragged
and moved right or left,
the Cylinder will move
accordingly.
Click [FILE]
