DW -Pro 9200 Series, Operation Instructions Manual

Page: 65 / 114

1.7 Communication setup
1
2
3
[Type of connection]
• LAN, PSTN, ISDN, Leased Circuit can be used for
remote connection.
ISDN or Leased circuit with router connection is possible
and ISDN or PSTN can be used to connect to DVR
without router directly.
• If you don’t use remote connection check on “not use”
• [Live Video stream bandwidth]
Set the bit-rate control per second of the image
transmitted to the network.
[Password]
• Enter 4 digit number password to log in site from
Center P.C. (Input must be NUMERIC and 4 digit).
• [Password] : Enter the 4digit number password
• [Confirm] : Re-enter the password to confirm.
[Emergency Connection]
[Motion for Emergency Message ]
• If motion occurs on the selected camera, it gets directly
reported to the inputted IP address to Emergency
Monitor.
(Transmission camera is set when number is pressed,
and Emergency Monitor must be running for the PC that
has center program installed.)
[Emergency Screen Transmission]
• If the sensor detects any signal it sends alarm to the
center with the captured image during the designated
time.(You can assign the external sensor number.)
[Tip]
When you try to connect to site from center
P.C., DW9200 checks the site code and
password together, and If they are not
identical, it will be disconnected automatically.
(When the site program uses an unfixed IP,
the center program cannot access the site
program.)
L L L L