Operator’s Manual – Spider CROSS LINER
30
Always fill the fuel tank at the end of the work shift. This will prevent condensation on the tank walls.
FILLING THE FUEL TANK
1) Secure and turn off the mower engine by pressing the CENTRAL STOP.
2) Remove any unwanted material from around the fuel cap.
3) Remove the fuel cap.
4) Add fuel with the filler neck as required.
5) Install the fuel cap. Make sure it is properly tightened.
5.11 OPERATING CONDITIONS
Observe the following precautions. It will make it easier for you to start operating and prevent possible damage to
the mower.
The mower is designed to operate under atmospheric temperatures
between -
20° C and 46° C
.
BASIC MEASURES
•
Use lubricating oils with the correct viscosity. See also:
FLUIDS, LUBRICANTS AND FILLING VOLUMES
•
Use hydraulic fluid with the correct viscosity. See also
: FLUIDS, LUBRICANTS AND FILLING VOLUMES
•
Keep the battery fully charged.
•
Always fill the fuel tank at the end of the work shift. This will prevent condensation on the tank walls.
•
Protect the mower while it is out of service. Park the mower inside of a building or cover it with a tarpaulin.
Ensure the engine is cold when covering.
•
Check the air vents. Make sure that the air vents leading to and from the engine compartment are not blocked.
OPERATION IN DUSTY OR SANDY AREAS
•
Check the air filter regularly, clean or replace the relevant parts as needed, regardless of the inspection interval.
•
Tighten the hydraulic tank filler cap tightly to prevent sand and dust from entering the hydraulic system. See
MOWER MAINTENANCE PLAN
•
Check for dirt accumulation in the engine and exhaust compartment.
OPERATION ON WET OR SOFT TERRAINS
•
Clean the mower. Moisture or dirt can damage paint, electric and hydraulic lines or metal parts. When operating
the mower, keep it as dry as possible and lubricate the mower regularly.
•
Check for dirt accumulation in the engine and exhaust compartment.
