47
HEA
T PUMP
46
4.1.2. Multi-brand heat pump with LINK dongle
Multi-brand heat pumps with the LINK Dongle will be recognized as a
‘DURAHEAT’ heat pump and are wired in a similar way as the above ‘DURA-
HEAT’ heat pumps.
The designated connection terminal blocks need to be used to connect the
‘DURAHEAT’ heat pump to the LINK Master.
DLM-600 heat pump wiring
4.1.3. Multi-brand heat pump without LINK dongle
Multi-brand heat pumps are not supported. They need to be installed and
operated as a stand-alone device.
Therefor the designated connection terminal blocks on the LINK Master
cannot be used for the electrical connection.
4.2. Configuration
4.2.1. Pairing the DURAHEAT heat pump
Multi-brand heat pumps with the LINK Dongle will be recognized as a
‘DURAHEAT’ heat pump and are paired in a similar way as the ‘DURAHEAT’
heat pumps.
For the ‘DURAHEAT’ heat pump to work correctly it needs to be paired with
the LINK Master. Be aware that the LINK Touch and DuraCloud App require
that the ‘DURAHEAT’ heat pump is paired first.
Please follow the sequence below to pair the ‘DURAHEAT’ heat pump.
-
Press the ‘DuraLink’ button on the LINK Master controller keypad
o
The led light will be switched ON showing the discovery/
pairing mode is active. The LINK Master will stay in
discovery/pairing mode for 15 minutes.
-
When the led light ‘Heating’ remains OFF this means no ‘DURAHEAT’
heat pump is yet connected.
-
Click on the ‘Heating’ button to pair the LINK Master with a new
‘DURAHEAT’ heat pump.
-
The light will be blinking slowly during this pairing process.
-
When a successful connection has been established, the light will
blink 3 times fast and the ‘Heating’ light will remain constantly on.
-
The pairing mode can now be closed by pressing the DuraLink
button
-
The LINK Master will go into automatic mode
-
Heatpump will start up, and after 1 – 2 min. the temperatures
should appear on the LINK Touch and DuraCloud App.
Only one ‘DURAHEAT’ heat pump can be connected with the LINK Master at
a time. For a new ‘DURAHEAT’ heat pump to be connected, the pairing pro-
cess needs to be executed again. This will overwrite the existing connection.
Once the pairing is complete ensure that both the LINK Touch and Dura-
Cloud App show the same temperature set-points as the display on the
‘DURAHEAT’ heat pump.
When this is not yet the case, the same pairing process needs to be repeat-
ed.
